How 1 ton per hour rice mill machinery works

1. Wiring requirements: 1 ton per hour rice mill machinery cannot be shared with the original lighting circuit. It must be connected directly from the main power switch with a copper wire or aluminum wire of more than 4 square millimeters. It is not possible to use a socket. It is recommended to use more than 10A. Knife switch.

2. Before starting the machine, carefully check whether the fasteners in each part of the machine are loose, and open the cover to check whether the gap between the rice rolls is correct. Generally, the gap between the rice knife and the tip of the rice roll is about 3 mm at the beginning of the rolling and 2.5 mm at the end of the rolling.

3. Turn on the switch, wait for 1-3 minutes of idle running, if the operation is normal, it can be fed with materials for processing. When opening the feeding board, it should be slowly pulled out to gradually increase the load of the machine, otherwise the sudden increase may cause the machine to block the car.

4. When stopping in the middle, the feed inlet should be closed first, and the rice mill machinery of 1 ton per hour should finish grinding before stopping.